26
9. Parameter Setting
Communication Status Indicator
The e-manage mark indicator in the top right corner will show the current online status.
OFF LIN
ON LINE
ON LINE Communicating at real time
ON LINE Recording Data
Communication
• Real Time Communication
Select to communicate with e-manage Ultimate at real time.
• Import Data (R) Ctrl+R
To import data from e-manage Ultimate on to the desk top.
• Compare Data
To compare the data in the e-manage Ultimate with the data on the desk top.
• Export Data (W) Ctrl+W
To export data to e-manage Ultimate from desk top.
• Main Unit Update
To update the E-manage Ultimate main unit.
Help (H)
• Version Information
To check the current software and main unit version type.
Software version type.
e-manage Ultimate main unit firmware version.
e-manage Ultimate main unit update file version.
Steady Yellow
Steady Green
Flashing Green
Steady Red
19
8. Parameter Setting
Ignition
Channel Configuration
• When the engine type is selected in the “Vehicle” setting the number of the ignition input and
output channels is automatically set.
• In this section each ignition input and output channels can be configured.
• Disrtibuter and group ignition type engines can be converted to individual ignition system by using
cam and crank angle signals with neccesary ignition system modifications and wiring.
Activate the IGN output channels for the IGN Adj. Map they are used for.
Right click to view the menu and left click to select.
• make to set the “Shift Up” rpm value is lower than “IGN cut rpm”.
IMPORTANT
Select the switch used to activate the “Shift Up” ign. cut.
The switch must be configured in the “Front Panel” and
connected to the Option 1 or 2 Port. Switch can be cluch
switch or shift up switch on a sequential transmision.
Input the start rev cut rpm. This will only activate only when
e-manage does not detect vehicle speed signal and throttle
position is above set value in “Throttle Position”.
Input range: 0~9999rpm 1 rpm increment
Input the max rev limit rpm. This will not eleminate the
factory rev cut. Input range: 0~9999rpm 1 rpm increment
Input the rpm limit while shifting up. (power shifting)
Input range: 0~9999rpm 1 rpm increment
Ignition cut will activate when throttle position exceed
above the input throttle position % value.
Input range: 50~100%, 1% increment
Ignition timing can be adjusted while the ignition
cut is activated. Place a check mark in the boxes and input
the adjustment value.
Input the number of vehicle speed signal pulse it take to
detect vehicle movement and to cancel the start rev cut to
normal max rev limit.
Ignition Cut Feature
• This section can be used to configure the ignition cut feature to set a rev limiter at verious
conditions. (This feature will not eliminate the factory rev limiter. See Rev Limiter Cut Setting)
• Set the “Start” rpm for launch control. When there are no vehicle speed signal and throttle is open
above the set %, the ignition cut will be activated.
• “IGN cut rpm” sets the max rev limit, and “Shift Up” will prevent over rev while power shifting
using a switch.
Make the neccesary changes by selecting the number of input and output CH
numbers.